Actual modelling progress (aka take that #6MMRPC!)

I'm not sure whether it was having the day off, the nice weather or the fact it's the Carronade Wargames show this weekend (Scotland's biggest). Whichever it was I got myself organised and actually did some hobby related work.

The first was cleaning all the vehicles I have been prepping over the last few weeks. I had meant to do this on Saturday and then Sunday...

Several of these blisters have more than one vehicle in them. Not a huge amount of work to clean them all, just time consuming.

I have seen a bit of discussion recently on one of the FoW Facebook groups on whether there is a need to wash your mini's. Honestly, if you saw the colour of the water after washing this lot you would clean all your mini's. I have no idea what effect all that crap has on the painting, but I don't want to find out!

Then I decided to spray some models - this became a bit of a job as I first tried the Plastic Soldier Company British Armour spray directly on to my Forged in Battle Universal Carriers. The FiB Carriers are a white resin, and the spray just did not go on properly. Now, this may be an issue with the spray or just with the colour of the resin. I dug around and found a can of Black (a Armypainter one) and gave them a skoosh. Then went back with the Plastic Soldier Company green. I also did the Churchill Croc I had done before as I wasn't happy with the tone of the green going on without a black undercoat.

So that's 12 Universal Carriers (+1 that was almost ready to be sprayed, I think it might end up being the 4.2" Spotter carrier), 1 Churchill Croc and 3 Wasp Carriers.

Then, since I had sprayed stuff and it was still nice, I decided to try my Dark Tone Army Painter dip. Slight issue with this since I left it sitting out open last summer, it's gone very thick and I may have to replace it. Still, I decided to do a tank or two, and a few hours later...

I'd done my whole winter backlog.

'A' was a little miffed to come home to me and the kitchen stinking of turps tho!

One thing I have discovered with the Army Painter dip is that previously I had just been dabbing off the excess and having to do a bit of work afterwards due to the amount of dip still on the model. Now I splodge it on, leave it a minute or two then dab off the excess. I then wash the brush in turps again, wipe off most of it leaving the brush a little wet, and do a 'reverse drybrush'. The turps still on the brush takes the dip off the higher points and makes the details 'pop' a bit more while still giving shade where it's needed. Hopefully that's not compromising the varnish, but I'm pretty sure there is turps in the AP.

So, that was my May bank holiday!